OHAUS Valor 3000 Instruction Manual - 7.4 Compliance
EN-18 Valor 3000 Series Scales
7.4 Compliance
Compliance to the following standards is indicated by the corresponding mark on the
product
.
Marking Standard
This product conforms to the EMC directive 2004/108/EC, the Low
Voltage Directive 2006/95/EC and the Non-automatic Weighing
Instruments Directive 90/384/EEC. The complete Declaration of
Conformity is available from Ohaus Corporation.
AS/NZS4251.1 Emission, AS/NZS4252.1 Immunity
NSF/ANSI 169 – 2005
NSF/ANSI /3-A 14159-1 - 2002
Important notice for verified weighing instruments
Weighing Instruments verified at the place of manufacture bear
one of the preceding mark on the packing label and the green ‘M’
(metrology) sticker on the descriptive plate. They may be put into
service immediately.
Weighing Instruments to be verified in two stages have no green
‘M’ (metrology) on the descriptive plate and bear one of the
preceding identification mark on the packing label. The second
stage of the initial verification must be carried out by the approved
service organization of the authorized representative within the EC
or by the national weight & measures (W+M) authorities.
The first stage of the initial verification has been carried out at the manufacturers
work. It comprises all tests according to the adopted European standard EN
45501:1992, paragraph 8.2.2.
If national regulations limit the validity period of the verification, the user of the
weighing instrument must strictly observe the re-verification period and inform the
respective W+M authorities.