Ohlins FGRT 219 Mounting Instructions

Summary of FGRT 219

  • Page 1

    Front fork for yamaha yzf-r1 fgrt 219 mounting instructions otte! 1 please note that there can be small differences between your product and the images in these instructions. Otte! 1 please note that during storage and transport, especially at high ambient temperature, some of the oil and grease use...

  • Page 2: Mou Ti G I Structio S

    2 1 put the motorcycle on a work stand so that the front wheel barely touches the ground. 2 remove the front fender, brake calipers, speed sensor and the front wheel. Refer to the vehicle service manual for correct procedure. Mou ti g i structio s arninge! ⚠ we strongly recommend to let an authorize...

  • Page 3: Mou Ti G I Structio S

    3 mou ti g i structio s 8 tighten: upper triple clamp: 20 nm lower triple clamp: 10 nm 9 install the front fender, front wheel and the brake calipers. Do not tighten yet. 11 arninge! ⚠ ensure that the speed sensor cable does not touch the wheel at full lock turns and when the suspension is fully com...

  • Page 4: Setup Data

    Öhlins racing ab box 722 s-194 27 upplands väsby, sweden phone +46 8 590 025 00 fax +46 8 590 025 80 © Öhlins racing ab. All rights reserved. Any reprinting or unauthorized use without the written permission of Öhlins racing ab is prohibited. Öhlins products are subject to continuous improvement and...