Ohlins FGRT 219 Mounting Instructions - Mou Ti G I Structio S
3
Mou tI g I stRuCtIo s
8
Tighten:
Upper triple clamp: 20 Nm
Lower triple clamp: 10 Nm
9
Install the front fender, front wheel and the
brake calipers. Do not tighten yet.
11
arninge!
⚠
Ensure that the speed sensor cable does not
touch the wheel at full lock turns and when the
suspension is fully compressed or extended.
Install the speed sensor bracket:
Place the sensor cable bracket at the rear
screw (position A) that holds the rear fender
bracket. Cable routing according to the figure.
Ensure that the speed sensor cable does not
touch the wheel at full lock turns and when the
suspension is fully compressed or extended.
12
Put the vehicle on the ground, apply the front
brake and compress the front fork distinctly
3-4 times. This will position the front fork legs
parallell.
13
Tighten the front axle, brake calipers and the
front fender.
Front axle pinch bolts torque: 19 Nm
14
Close the compression and rebound adjusters.
15
Compress the front fork as much as possible
several times to bleed out the air. Ensure that
there is damping on the full stroke.
16
Set the compression and rebound adjusters,
see setup data on the next page.
Cautione!
✋
Make sure that you tighten all screws to the
correct torque and that nothing fouls or restricts
movement of the front fork when the suspension
is fully compressed or extended.
Cable behind
the brake hose
Hose down
towards
the speed
sensor.
Speed sensor
bracket on the
outer side of
the brake hose
attachment.
A
The tab of
the bracket
below the
rear fender
bracket.
Torque and
thread locking
according to
vehicle service
manual.
11
aDjustMe ts
arninge!
⚠
Before you ride/drive, always make sure that the
setup is according to the recommended setup
data. Read about adjustments and setting up
in the Öhlins Owner’s Manual before you make
any adjustments. Contact an Öhlins dealer if
you have any questions about set up.
Spring
preload
adjuster
Compression/
Rebound
adjuster