Ojocam PRO 2 User Manual - page 8
7
6. LDWS CALIBRATION: Red line is the Skyline, Yellow line is hood line
7. Flicker: 50/60Hz (For United States and Canada, please choose 60Hz)
8. White Balance: Auto (recommended), Sunny, Cloudy, Fluorescent, Incandescent (White
Balance is for correction under different lighting conditions. When White Balance is set
to Auto, the camera will automatically compensate for different lighting conditions)
9. EV (Exposure Value):-2.0,-1.7,-1.3,-1,-0.7,-0.3,0,+0.3,+0.7,+1.0,+1.3,+1.7,+2
10. Recycle/Loop setting: 1min, 3mins, 5mins, OFF
11. Motion detect: off/on
12. Time set: time off set, year/ month/day Time
If the unit comes with the optional GPS, the UTC time offset needs to be adjusted to your
time zone. The time setting is accessible via camera menu Time. Check the Internet for
a list of UTC offset for time zones.
13. AUTO power off: 1min, 3mins,5mins, off
14. Power off screen : off/1minutes/3 minutes/5minutes
15. Date/Time Stamp: Driver Number stamp/OFF/Date Time
16. Driver Number stamp (a customizable text overlay field)
17. G-sensor Sensitive: 2G/2.5G/3G/3.5G/4G/4.5G, CLOSE
4.5G and 2G are the most and least sensible setting.
18. G-sensor calibration: Yes / No
19. GPS: On/off (only for the camera with GPS function)
20. Language: English/Russian/Chinese
21. Default setting: Yes/No (This function will restore all the settings to the factory
defaults.)
22.Format: Yes/no (Use this function to format a storage card - note that all the data stored
on memory card will be erased, please back up information before proceeding with this
operation)
23. Firmware version: Display firmware version information
3.2 Text Overlay: Date and Time, License Plate Number, Off
• In Car Mode, the location coordinates (latitude and longitude) will be displayed on the
LCD screen (GPS version only).
• After setting up Date, Time, and License Plate Number, if driver number is not shown on
the screen, it means the device has insufficient storage space.
• Driver Number is 9-character license plate number.
3.3 Setting Language
Turn on the camera using the Power button. Press Menu (long press the Up button),then
press Up and Down buttons to choose language. Press OK button to confirm.