OK-I SDMIVD35-55AIDN Operational Manual - page 3
SDMIVD35-55AIDN_ SDVD-55AIDN_rev09192008
3
Step 1: Camera Cabling
A. Decide how the camera will be mounted.
B. Decide how the cable will be connected to the camera.
a.
Using ½” pipe from the side
b. Using the cable hold at the base of the camera with or without pipe
C. Be sure to use proper waterproofing process regardless of what method you use to connect the cable.
NOTE: Warranty will be VOIDED if camera is damaged by water or moisture due to improper installation without waterproofing.
Step 2: Removing Dome Cover
Remove dome cover from the main body by loosening the four dome cover mounting
screws. The dome cover is fixed with tamperproof screws. Loosen the four dome cover
mounting screws by using the supplied bit for tamperproof screws.
Step 3: Securing Camera
Place mounting plate at position which the camera will be mounted and fix the screw holder and then screw 4x 26mm screws x4.
Step 4: Focus & Angle Adjustment
We have provided a service monitor RCA connection jack for your convenience.
INSTALLATION