OK-I SDMIVD35-55AIDN Operational Manual - page 5
SDMIVD35-55AIDN_ SDVD-55AIDN_rev09192008
5
Step 6: Function Setting
You can select the function according to your condition. Please see the above image for factory default values whenever a
camera needs to be set to default again during an installation.
Auto Iris and AES Adjusting – Dipswitch 1 (IR D&N ICR & Hi-Res.)
Please select the Auto Electronic Shutter mode to control exposure with the electronic shutter. The range of shutter speed is from
1/50 (1/60) set to 1/100,000 sec.
Flickerless Function Adjusting – Dipswitch 2 (IR D&N ICR)
If a camera is installed into a different frequency, the Flickerless function will reduce the flicker of video. The shutter of NTSC is
1/100; shutter of PAL is 1/120. When the dip switch is at AES/FL side, the shutter will stay at Flickerless situation.
AGC – Dipswitch 3 (IR D&N ICR) / Dipswitch 2 (Hi-Res.)
If you are to install the camera in a low lux environment, switch to AGC so that it will increase the camera sensitivity. The default
setting is AGC.
White Balance Adjusting – Dipswitch 4 (IR D&N ICR) / Dipswitch 3 (Hi-Res.)
AWB mode – Conventional auto white balance – This mode is factory default setting
ATW mode – Advanced white balance – This mode is limited (color temperature 2500°K~9000°K
Auto Back Light Compensation – Dipswitch 5 (IR D&N ICR) / Dipswitch 4 (Hi-Res.)
This intelligent auto BLC is a newly developed digital light level control system. It is activated automatically by screen histogram
(contrast) and 225 area window weighing integration to control iris gain and white balance simultaneously.
Central Window Weighted average Back Light Compensation
This method is suited for cases where the main subject is fixed within the screen.
Histogram Back Light Compensation
This method is suited for cases where the main subject moves about within the screen.
Mirror Adjusting – Dipswitch 6 & 7 (IR D&N ICR) / Dipswitch 5 & 6 (Hi-Res.)
If the camera is installed in elevators, lifts or viewing directly to a mirror, please adjust to horizontal mirror mode. If the camera
must be installed upside down due to installation limit, please adjust to vertical mirror mode.
Factory Default