DL manuals
Oki
Wireless Router
B710dn
Maintenance Manual

Oki B710dn Maintenance Manual

Other manuals for B710dn: User Manual, User Manual, Material Safety Data Sheet, Setup Manual, Hardware, Installation Sheet

Manual is about: Oki B710n: User Guide

Page of 8

Download

Print this page

Bookmark us

B700 Series 200K Page

Maintenance Kit Instructions

The following document outlines the procedures to install the fuser assembly, BTR roller,

and retard roller assemblies included in the B710/720 and the B730 200K page

maintenance kits.

B710/720 Kit Part Number - 58284203 B730 Kit Part Number - 58284204

Fuser Replacement Procedure

Removing the Old Fuser Assembly:

NOTE: If the unit was recently running please turn off and allow 30 minutes for the fuser

to cool down before starting the replacement procedure. Fuser gets extremely HOT.

1. If there is a duplexer installed on the unit press button to release the duplexer

assembly and drop into an open position.

2. Squeeze the two tabs to open the rear cover.

3. Push down on both of the orange tabs to release and remove the fuser.

1 2 3 4 5 6 7 Next › »

Summary of B710dn

Page 1
1 b700 series 200k page maintenance kit instructions the following document outlines the procedures to install the fuser assembly, btr roller, and retard roller assemblies included in the b710/720 and the b730 200k page maintenance kits. B710/720 kit part number - 58284203 b730 kit part number - 582...
Page 2
2 installing the new fuser assembly 1. Line up the connector on the fuser with the connector on the printer and insert the new fuser. Fuser connector printer connector 2. Lock the fuser in position by pushing up on the orange tabs..
Page 3
3 b710 b720 and b730 fuser counter reset procedure -instructions for resetting the maintenance counters- first, enter the diagnostic mode in order to do a maintenance counter reset. To enter the diagnostics area: turn the printer power off. Press and hold the menu^ and enter buttons. Turn the printe...
Page 4
4 replacing the retard rollers 1. Gently push the notch on the tab away from the groove in the shaft. 2. While holding the tab clear of the shaft move the roller toward the groove in to remove. 3. Repeat the procedure to remove the rollers at all three locations shown below. 150 paper cassette assem...
Page 5
5 150 feeder assembly 550 feeder assembly 550 paper cassette.
Page 6
6 installing the new retard rollers 1. Install the roller by aligning the shaft with the opening in the roller and push the roller over the groove in the shaft until the notch on the tab locks into place..
Page 7
7 btr kit instructions the following document outlines the procedures to install the new btr assembly . Red circle shows fuser location, btr assembly located directly under fuser. Note: before removing the btr roller, open the top access cover, and remove print cartridge. 1. Reach inside through the...