Le810dt setup guide.
Le810dt operator panel print head print assembly media holder print head latch media hold- down backing take-up spindle platen roller top access door front access door media supply guide backing retainer prongs print head latch backing drive roller dispenser latch outside media guide sensor adjust k...
6 2 4 3 4 5 1. Open the top access door by swinging it up. 1 2. Open the front access door by pushing down on the green dispenser latch and swinging the door forward and to the left. This gives access to the print mechanism on three sides. Note: the top access door must be open before the front acce...
14 13 12 10 5 11 b 8. Raise the outside media guide to the closed position and push the guide inward until it barely contacts the outside edge of the media. 9. If your printer does not have an internal rewinder, then skip to step 14. 10. Remove 24" to 30" of labels from the backing paper to provide ...
Le810dt install the driver 1. Insert the printer software cd in the cd-rom drive. The cd will autorun. 6 2. Select your language. 3. If you accept the license agreement, select i accept . 4. Select install driver under driver setup. 5. When the add printer wizard appears, select next ..
7 6. Select okipos le810 and then select next. 7. Select the port that your le810dt is connected to from the list of available ports. If you want this printer to be your default printer, then check the box next to “i want to use this printer as the windows default printer”. Select next when complete...
59403601.
