Oki ML8810 Installation Instructions
1: English
Installation Instructions
OkiLAN
®
7120e
OKI, OkiLAN ® Oki Electric Industry Company, Ltd.
Ethernet ® Xerox Corp.
Notes: This print server is FCC and IC Class A
compliant.
No Ethernet
®
cable is supplied. Use an
Ethernet cable with two twisted wire pairs
and an RJ45 plug.
1. Turn off the printer and unplug the power cord.
2. Remove the screws (1) at either end of the
mounting bracket on the back of the printer.
3. Slide the bracket out of the printer.
4. Remove the snap-out plastic piece (1) from the
mounting bracket.
5. Note the plastic release clip (1) and the metal
spring (2) on the mounting bracket.
6. Position the print server under the plastic
release clip (1) and over the metal spring (2)
and slide it into the mounting bracket until you
hear it click into place.
7. Insert the bracket/card into the printer. Push in
firmly. Make sure you feel the connection pads
(3, above) at the back of the print server plug
into the printer.
8. Reinstall the screws on the bracket.
9. Press the SW button (1) on the print server.
The test pages print.
10.
Connect your Ethernet cable to the print server,
then to the network
.