Oki OKICOLOR8cccs Setup Manual

Setup Guide

|

1

Remove the accessory tray

and check the contents

Select a Location

• Firm, level surface capable of supporting

at least110 lbs (50 kg).

• Clearance to open cover, paper tray and

Special Media Stacker (rear exit)

• At least 4 inches (102 mm) additional

clearance on both sides

• Nearby power source

• Room temperature:

–

Ideal: 62.6 to 80.6ºF (17 to 27ºC):

–

Maximum Permissible: 50 to 89.6ºF

(10 to 32ºC)

• Relative humidity:

–

Ideal: 50 to 70% RH

–

Maximum Permissible: 20 to 80% RH

• Away from direct sunlight

Unpack

Remove Packaging

!

The printer weighs approximately 106

lb (48 kg). Use a least two (2) people to

carry the printer. Use appropriate lifting

techniques.

1 Remove the top cushions.

2 Lift the printer from the box and place it

on a suitable support.

3 Remove it from the plastic bag.

4 Remove the shipping tape.

5 Remove the control panel protective film.

6 Open the front tray and pull out the

shipping retainer, then close the tray.

Overview

1 Unpack ........................................ 1

2 Install the Toner Waste Box... 4

3 Install the Oil Roller ................ 5

4 Prepare the Image Drums ...... 6

5 Install the Toner Cartridges ... 7

6 Load paper ................................. 8

7 Connect to Your Computer .... 8

8 Connect to Power ..................... 9

9 Print the Demo Page ............... 9

10 Install Software ........................ 9

11 Calibrate the Color ................. 10

• Toner cartridges

(1 each: black,

magenta, cyan,

yellow)

• Toner Waste Box

• Oil Roller

• CD

• Image Drum Storage

Bags (4) and

Lens Cleaners (4)

• Power Cord

1