Oki WDS-HDR1520 Operating Manual - 4. User Osd Setting

● 

Applicable for WDS-HDR1527DN & WDS-HDR1520 

▲ Only Applicable for WDS-HDR1527DN 

 -4 

- 

E.  Auto iris lens connector (MINI JACK) 

Use with accompanying auto iris lens control connector plug. 

Auto iris lens has built-in EE amp. (VIDEO Type) 

Set the lens selector to ”VD” position. 

Connector cable leads 

1.Red --- power 

3.White --- video 

2.NC 

   4.Black 

--- 

shielded 

Auto iris lens without EE amp. (DC Type) 

Set the lens selector to “DD” position. 

Connector cable leads 

1. Damping coil (-) 

3. Driving coil (+) 

2. Damping coil (+) 

4. Driving coil (-) 

F.  Video output terminal (BNC) 

This connector is used to connect with VIDEO IN connector of monitor.   

G.  On-Screen Display keypad 

H.  Slide out for control panel 

I.  Power pilot LED   

J.  DC12V / AC 24V Block Terminal   

This terminal accepts DC 12V (Non-polarity) or AC 24V.   

The other model: AC 85 ~ 265V. 

K. 

OSD Remote control connector (MINI JACK)

DC12V/AC24 MODEL 

L. 

The Device for sensing brightness level (for D/N function).

L.  Only

 Applicavle for WDS-HDR 1527DN 

4. USER OSD SETTING 

SETTING SWITCHES AND FUNCTIONS 

1.UP button-This button is used to move the cursor upwards. Use 

this button to select item. 

2.LEFT button –This button is used to move the cursor left. Use to

select or adjust the parameters of the selected item. 

3.RIGHT button-This button is used to move the cursor to the 

right. Use to select or adjust the parameters of the selected item. 

4.DOWN button-This button is used to move the cursor downwards. Use this button to 

select item.