Oki X400 User Manual - page 13
Other manuals for X400:
Safety Information Manual, User Manual, Installation Manual, Assembly Instructions, Install Sheet, Manual
Manual is about: X400 Programming Command Manual
of
76
12. Close the top cover.
9
3. Wait until the ERROR no more blinks and becomes OFF, press the FEED
1
button to feed a label or to resume printing.
3.3 Selecting the label sensor type
gap or notch label sensing. The
sensing method use by the printer must match to the media being used. If you
p these
ng
nter using direct commands, you must
OKIPOS X400 printers can use Eye-mark,
are using label printing software, it should provide a mean to set u
parameters. See your software documentation for details. If you are writi
your own software or controlling the pri
use printer commands to set up the printer mode and sensing method.