- DL manuals
- P3 International
- Vacuum Cleaner
- P4900
- Operation Manual
P3 International P4900 Operation Manual
Summary of P4900
Page 1
P4900 operation manual robotic vacuum.
Page 2: Table of Contents
Table of contents safety instructions -------------------------------------- 2 * safety rules * battery and recharging notes welcome ------------------------------------------------------ 3 major components and attachments -------------- 3 nomenclature --------------------------------------------- 4...
Page 3: Safety Instructions
Please read through the safety rules in this operation manual before operating this product and keep this manual for your future reference. The basic safety rules shall be strictly observed to prevent any occurrence of fire, electric shock and personal injury. The safety rules are described below. S...
Page 4: Welcome
Welcome 3 1.P4900 cleaner x1 2.Battery chamber for 12 rechargeable " aa" batteries x1 3.Dust bin filter x1 4.Operation manual x1 5.Dust mopping paper holder 6.Electrostatic dust mopping paper 7.Rechargeable " aa" battery x12 8.Ac power transformer x1 major components and attachments 1. 2. 3. 4. 5. 6...
Page 5: Nomenclature
Nomenclature 4 battery cover heat vent power switch socket for charger bumper intake wheel dust bin inside front small wheel back small wheel upper cover base power indication lamps.
Page 6
5 1.Make sure the smart cleaner is off. 2.Press and push the battery cover (please note the direction). 3.Mount 12 rechargeable "aa" batteries into the battery chamber one by one in compliance with the directions of the positive and negative poles as shown in the legends inside the battery chamber. ...
Page 7: Recharging Battery
6 recharging battery operation method starting operation 1.Clean the dust bin. 2.Place the p4900 robotic vacuum in a location in the room with the most free space. 3.Turn the power switch to the on position then the two power indication lamps will flash alternately. 4.When the battery runs out of po...
Page 8: Operation Method
Operation method using electrostatic dust mopping paper for non-carpet surfaces 1.Insert the border of electrostatic dust mopping paper into the grip slot of the dust mopping paper holder. 2.Aim the 2 holes of the dust mopping paper holder at the 2 bolts (inside the 2 big wheels) and click the holde...
Page 9: Cleaning and Maintenance
Cleaning and maintenance 8 maintenance method the operation and maintenance of the p4900 is very simple. After every use, clean any dirt left on the dust bin and filter. It is not necessary to clean the intake after every use. Cleaning dust bin 1.Press and push the battery cover (please note the dir...
Page 10: Cleaning and Maintenance
1.Open the upper cover of the dust bin. 2.Lift up and take out the filter. 3.Dump the contents of the dust bin into the trash bin. Cleaning and maintenance 9.
Page 11: Cleaning and Maintenance
Cleaning and maintenance 10 intake cleaning intake after repeated use, dust can accumulate around the intake of the p4900 and the working efficiency is therefore diminished. To ensure the best efficiency and constant air flow, the intake should be cleaned periodically. 1.Turn off the power and place...
Page 12
P3 international corporation limited warranty p3 international corporation ("p3") warrants to the original retail purchaser only, that its product is free from defects in material or workmanship under the condition of normal use and service for a period of six (6) months from the date of purchase. I...
Page 13
Copyright 2005 p3 international corporation - rev 08/05.