PA Tech Electronics QSM-606EP User Manual - page 6
- 6 -
GENERAL INSTALLATION
DO NOT run microphone cables near A/C lines, data, telephone or 70V line cables.
DO NOT run outputs line cable near data, telephone or other low voltage cables.
ENSURE that all loudspeakers are in-phase.
ENSURE that there are no short circuits on the loudspeaker line before connecting to the amplifier.
IMPORTANT
The wires in the mains lead are colored
In accordance with the following code:
Green and Yellow: Earth (E)
Blue: Neutral (N)
Brown: Live (L)
As the colors of the wires in the mains lead of this apparatus
may not correspond with the colored markings identifying
the terminals in your plug proceed as follows:
The wire that is colored green and yellow must be connected
to the terminal which is marked with the letter N or colored
black. The wire which is marked with the letter L or colored
red.
If a 13 Amp (B.S.1363) plug or any other type of plug is
used, a 5 Amp fuse must be fitted either in the plug or at the
distribution board.
WARNING: THIS UNIT MUST BE EARTH GROUNDED