- DL manuals
- PaceMaster
- Fitness Electronics
- Platinum ProClub
- Owner's Manual
PaceMaster Platinum ProClub Owner's Manual
Summary of Platinum ProClub
Page 1
Pacemaster platinum proclub owner’s manual manufactured by: pacemaster llc, 34 fairfield place, west caldwell, nj 07006, (973) 276-9700 www.Pacemaster.Com part # tmp1638 rev. 09/16/10
Page 2: Table of Contents
2 table of contents introduction 3 important safety instructions 4 assembly instructions 5-18 unpacking your treadmill 5 installation requirements 6 tools required for assembly 6 grounding instructions 6 assembly instructions 7-17 testing your treadmill 18 the pacemaster platinum proclub control pan...
Page 3: Introduction
3 introduction congratulations and thank you for choosing pacemaster – your partner in achieving your fitness goals and mastering your well-being. Pacemaster’s advanced digital technology allows your treadmill to process information instantly, anticipating and adjusting to meet your needs. Think of ...
Page 4
4 important safety instructions read these instructions before using your treadmill caution: before starting any exercise program, contact your personal physician and have a complete physical. This is highly recommended if you have not been on a regular exercise program within the last year, or are ...
Page 5: Assembly Instructions
5 assembly instructions unpacking your treadmill confirm that all of the items pictured below were packed in the box before assembling your treadmill, open the hardware package and verify that the contents of the package match the hardware legend included in the hardware package. If any parts are mi...
Page 6
6 assembly instructions (cont’d) installation requirements your pacemaster should be installed indoors on a flat, level surface near a 120volt/ 15amp outlet. Pacemaster requires a dedicated, non- switched outlet, that is not part of a gfi (ground fault interrupter) circuit, preferably no more than 5...
Page 7
7 1 2 3 4 a a b b 3/8"- 16 x 3/4" (8 pcs) 3/8" sae black washer (8 pcs) hardware needed assembly instructions (cont’d) step one: 1-1.Carefully lower the handlebar b on to its mounting brackets c as shown in the figure. The mounting brackets c must slide inside the handle bar b . 1-2. With the handle...
Page 8
8 purse lock clip shown closed assembly instructions (cont’d) caution: make sure the treadmill is not plugged into the electrical outlet until assembly is competed. Step two: with the handlebar bolted in place, plug the black wire harness ‘a’ into the socket ‘b’ on the power supply board. Twist open...
Page 9
9 1 6 5 8 10 9 7 a c a b d 1/4"-20 x 1.75" hex head bolt (4 pcs) 1/4" washer (4 pcs) hardware needed assembly instructions (cont’d) step four: 4-1. Loosely attach left panel support tube f by installing bolts ‘a’ and ‘c’, ¼-20 x 1 ¾” hex bolts g and ¼” washers h to the upright b . Do not tighten yet...
Page 10
10 8 5 11 12 a b b #8 x 1.5" pan head (4 pcs) hardware needed assembly instructions (cont’d) step five: 5-1. Route wire harness over the top of the right panel support tube f and rest in front of the cross brace as shown in the image below. 5-2.Route the contact hr wires in front of the cross brace....
Page 11
11 hardware needed 2 pieces of tape with backing t tape ape assembly instructions (cont’d) step six: 5-1. Route the wire harness as shown below. Plug in the harness into the display board. Pull the wire harness taut then apply one piece of tape exactly as shown. 5-2. Route the contact heart rate wir...
Page 12
12 13 hardware needed 2 pieces of tape with backing t tape ape magnetic safety key (1) assembly instructions (cont’d) step seven: tape the magnetic safety key z to the control panel back n exactly as shown. Note: you will have 1 extra piece of tape..
Page 13
13 13 14 11 #8 x 1.25" pan head (10 pcs) hardware needed assembly instructions (cont’d) step eight: screw together the two halves of the control panel l and n using the ten 1 ¼” inch pan head screws o . Start with the screw labeled 14 and proceed in a clockwise tightening sequence. Note: make sure y...
Page 14
14 hardware needed 15 16 17 assembly instructions (cont’d) step nine: 9-1. Slide the side rail adaptors r all the way onto the square handle bar support tube. 9-2. The side rails are labled left p and right q , slide the side rails over the side rail adaptors on their respective sides. The grip on t...
Page 15
15 21 20 19 16 18 1/4 - 20 kep nut (2 pcs) side rail mounting brackets (2 pcs) 1/4" sae silver fender washer (2 pcs) 1/4" - 20 x 5" slotted head bolt (2 pcs) hardware needed assembly instructions (cont’d) step ten: 9-1. Insert slotted head bolt s through the hole in the bottom of the side rail q . S...
Page 16
16 21 #8 x 1/2" screw (2 pcs) (side rails) hardware needed #8 x 3/8" screw (2 pcs) (motor cover) hardware needed 24 23 a a assembly instructions (cont’d) step eleven: the grip on the side rail must slide completely inside the control panel. Install the set screw w #8 x ½” into the predrilled hole on...
Page 17
17 assembly instructions (cont’d) step thirteen: assembly is complete; please proceed to testing your treadmill on the next page..
Page 18: Testing Your Treadmill
18 testing your treadmill your pacemaster has been adjusted and tested at the factory. However, due to changes that can occur during shipment, it should be tested prior to use. Once you have assembled your treadmill and it is located where it will be used, proceed as follows. (do not make any adjust...
Page 19
19 the pacemaster platinum proclub control panel although your pacemaster has many advanced features to provide versatility in meeting exercise needs, basic operation is extremely easy. Basic operation involves setting your time and speed goals, then pressing the start button. Your pacemaster will g...
Page 20
20 (quick) (reset) (enter) workout intensity level (timer) 0 1 2 3 4 5 6 7 8 9 the pacemaster platinum proclub control panel (cont’d) start (quick) – 1) use this button to quick start your workout with the press of one button. 2) in all other program modes, use this button to start your workout afte...
Page 21
21 the pacemaster platinum proclub control panel (cont’d) calories distance aerobic pts results button – 1)prior to beginning your workout, press this button to see the predicted caloric expenditure, aerobic points or distance for the workout you have chosen. 2) during your workout, press this butto...
Page 22: Operating Instructions
22 operating instructions initially, you may want to keep both hands on the side rails until you feel comfortable walking on your pacemaster. Once you feel comfortable, try removing your hands to let them swing naturally, as you would when walking outdoors. Always hold on to the side rail or front h...
Page 23: Quick Start
23 quick start quick start allows you to begin your workout by pressing one button. You control the speed, incline and time. Step one: stand on the running belt and attach the garment clip on the end of the magnetic safety key to your clothing. Insert the safety key into its recess on the control pa...
Page 24: Timed Workout (Manual)
24 timed workout (manual) timed workout allows you to choose the length of time and the degree of intensity for your workout. You can make speed and incline adjustments at any time during the workout. Step one: stand on the running belt and attach the garment clip on the end of the magnetic safety k...
Page 25
25 using the programmed workouts step one: stand on the running belt and attach the garment clip on the end of the magnetic safety key to your clothing. Insert the safety key into its recess on the control panel. Step two: press the incline buttons to set your weight, then press the (enter) button. ...
Page 26: Programmed Workout Profiles
26 programmed workout profiles note: your individual workout may differ slightly from the ones printed above, based on variables chosen by you, such as workout time and intensity level. Profile hand grip chest strap effort meter strenuous low moderate extreme conditioning level 4 conditioning level ...
Page 27: Using A Wireless Chest Strap
27 using a wireless chest strap train less and benefit more from your workouts to maximize the benefits from your workouts, you must maintain a sufficiently high heart rate. Target heart rate training takes the guesswork out of exercising. It provides you with the means to train within safe and effe...
Page 28
28 exclusive pacemaster features exercise preview you can see exactly what you will accomplish prior to beginning a timed workout (manual), or variable intensity workout. An exercise previewpredicts the total distance, caloric expenditure and aerobic points to be earned based on the time, incline an...
Page 29
29 exclusive pacemaster features (cont’d) tip: if you have selected your user id, go to step four. Step three: press the incline buttons to set your weight, then press the (enter) button. Step four: enter the workout time using the workout intensity level (timer) timer buttons until the desired work...
Page 30: Care & Maintenance
30 care & maintenance the following section describes necessary maintenance for your pacemaster treadmill. This maintenance is the responsibility of the purchaser and is not covered under our warranty. Failure to perform this necessary maintenance could result in damage to your treadmill. Caution: u...
Page 31
31 centering the tread belt to improve belt life, the belt should be reasonably centered. Run the treadmill at 2.5 mph for 3 minutes to allow the belt to settle in place. If the belt is not reasonably centered (no closer than 1/8” to the left or right deck shroud) follow the steps listed below. Warn...
Page 32: Troubleshooting
32 troubleshooting caution: unplug your treadmill before attempting any cleaning, maintenance, or service. Is the magnetic key inserted into the control panel? Is treadmill plugged into the wall outlet? Check the household circuit breaker to see if it is tripped. The treadmill will not operate if pl...
Page 33: Troubleshooting (Cont’D)
33 troubleshooting (cont’d) caution: unplug your treadmill before attempting any cleaning, maintenance, or service. Error code 117 this error will occur if the control panel is on and the user pushes the belt. If this error appears during a workout the user is manually pushing the belt faster than t...
Page 34: Troubleshooting (Cont’D)
34 figure 8 figure 7 troubleshooting (cont’d) check the both wiring connections between the elevation motor and the power supply. Also, check the wiring harness for cuts or visual damage. If “err” appears in the incline display after attempting an elevation change, the control panel did not see elev...
Page 35: Troubleshooting (Cont’D)
35 1 keep treadbelt reasonably centered 2 figure 9 troubleshooting (cont’d) tread belt tension adjustment step one: locate the two tread belt adjustment screws (#1 & #2 in fig 9) as shown. Step two: turn both the left and right tread belt adjustment screws 1/2 turn clockwise. Step three: walk on the...
Page 36: Frequently Asked Questions
36 frequently asked questions q. Why is time displayed as a negative number (i.E. – 1:15)? A. The treadmill’s computer displays time in minutes and seconds (mm:ss) for workout times less than 1 hour, and in hours and minutes ( – h:mm) for workout times 1 hour or greater. – 1:15 represents one hour a...
Page 37
37 pacemaster platinum proclub technical specifications boxed dimensions 83”l x 33”w x 19” h assembled dimensions 73”l x 32” w x 54”h boxed weight 239 lbs. Assembled weight 205 lbs. Frame welded aircraft grade extruded aluminum alloy running surface 60”l x 20”w drive motor 3.0 hp continuous duty dc ...