PaceMaster Pro-Plus HR Manual - Unpacking Your Treadmill
• Where to install your treadmill? Your treadmill should be installed indoors on a flat level surface near a 120Volt/ 20Amp electrical outlet, preferably
no more than 5 feet from the outlet to eliminate the need for an extension cord. You must have a minimum of 4 feet clearance between the rear of
the treadmill and any wall or obstruction.
If you are installing your treadmill on a carpeted surface, use a pad or scrap piece of carpet in between to avoid marking or soiling of the
carpet. Deep pile carpet is not recommended.
Unpacking Your Treadmill
• The PaceMaster is packed in five pieces: the main unit, the handlebar, the siderails, the motor cover, and the hardware package that contains this
manual. Once you have removed all of the pieces from the box, inspection of the treadmill should be made to check for any concealed damage that
may have occurred during shipment.
• Before assembling your treadmill, open the hardware package and verify that you have the following items.
2 -------- 1/4 - 20 x 4” black carriage bolt
1 -------- 3/16” Allen wrench
4 -------- 1/4-20 x 3.5" silver carriage bolt
1 -------- magnetic key with garment clip
6 -------- 1/4-20 kep nuts
2 -------- insulator spacers
3 -------- #8 x 1/2 black sheet metal screws
8
--------
insulator bushings
2 -------- black siderail brackets
1 -------- CardioSport wireless chest strap transmitter
2 -------- 1” OD fender washers
If any parts are missing please contact your authorized PaceMaster dealer.
Tools Required for Assembly
• 3/16" Allen wrench (supplied)
• 7/16 combination wrench
• Phillips head screwdriver
Assembly Instructions
CAUTION: Be extremely careful not to damage the speed
sensor (Figure 2) while installing the handlebar or motor cover.
1. Place two of the insulator bushings in the holes in the top of the frame for
the handlebar as shown in figure 1. Now place one of the insulator
spacers on top of the frame making sure that the holes in the spacer go
over the two bushings placed in the frame previously. It is very important
to make sure that the top surface of the spacer is above the top of the
bushings. Carefully place the bottom of the handlebar on the frame so
the two holes in the plate at the bottom of the handlebar line up with the
two holes in the frame. Insert two 3.5” carriage bolts #1 through the
handlebar and the frame. Install an insulator bushing on to each carriage
bolt with the narrow end up and slide the bushing up into the frame. Install
a kep nut #2 on to the carriage bolt to keep the handlebar in place (Make
sure
the
insulator bushing is in place after installing the kep nuts).
Follow the same procedure for the other side of the handlebar. Do not
tighten any nuts until both sides are bolted in place.
Figure 1
2. With the handlebar in place plug the wire harness #3 into
the socket #4 on the power supply board (figure 2).
4