PACH & COMPANY AeGIS 8000 Series Installation And Programming Manual - page 19
Pach and Company
Chapter 3
Page 12
AeGIS 8000 Series
PROGRAMMING
FUNCTION CODE
PROGRAMMING
08
SYSTEM ID NUMBER
(DEFAULT SETTING IS =1 )
Not applicable, do not change the default setting.
09
DIRECTORY DIGITS
(DEFAULT SETTING IS=3)
Directory is used to identify a tenant name. It
must be unique for every tenant. The directory
code is used for direct dialing (see system
operation) and to modify and delete the existing
tenants.
Directory digit must be selected before to do any
programming. If 3-digit directory code is
selected, you must use 3-digit directory code for
all tenant.
Step 1
Log on to programming mode, see instruction above. The display
will show
Step 2
Enter function code 09 then press #, the display will show
Step 3
Enter the directory digits 2, 3 or 4 then press # or press * to keep
the current setting.
Step 4
Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
10
CHANGE THE WELCOME MESSAGE
(DEFAULT SETTING IS
(“ Welcome to Pach’s Telephone Access
System”)
The welcome message consists of three
segments. Each segment is 16 characters long.
Step 1
Log on to programming mode, see instruction above. The display
will show
Step 2
Enter function code 10 then press #, the display will show
1st segment
Step 3
Press * to erase the current message then enter a new one using
the keypad (press # every character you have entered) then press
## after the last character you have entered to proceed to the 2nd
segment, the display will show
2nd segment
Step 4
Press * to erase the current message then enter a new one using
the keypad (press # every character you have entered) then press
## after the last character you have entered to proceed to the 3rd
segment, the display will show
3rd segment
Step 5
Press * to erase the current message then enter a new one using
the keypad (press # every character you have entered) then press
## after the last character you have entered.
Step 6
Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
Select Func: _ _
DIR DIGITS: 3
Select Func: _ _
Welcome to Pach’
s Telephone Acce
ss System ... **