PACIFIC CYCLE 22-PS311 Owner's manual and assembly instructions - page 7
7
©2006 Pacific Cycle, Inc.
2
Remove the hardware from the arm of a
corner leg fitting in order to insert one of
the legs.
NOTE: Four leg sections are shorter than
the others. These are the center legs. Also,
one leg has two holes near the base. The
see-saw attaches to this leg and needs to be
placed on the opposite side of the slide.
Part Ref. #: PSHW10
4
Align the two sets of holes and replace the
hardware through the corner leg fitting and
leg to secure.
Part Ref. #: PSHW10
5
Repeat the process for the other side of the
corner leg fitting.
Part Ref. #: PSHW10
6
Assemble the center legs and the remaining
outside legs in the same manner as above
and then stand the swing set frame upright.
Part Ref. #: PSHW10
7
Remove the hardware for the support bars
from the leg sections. Match up the holes
of the mid-leg and support bar and re-insert
the hardware through both. Repeat the
process for the opposite side and 2 sets of
center legs. It may be necessary to pull
both legs towards each other in order for
the holes to align properly.
NOTE: One support bar has holes for the
slide attachment. The holes should be
positioned toward the front of the swing set.
Part Ref. #: PSHW12