Pacific Energy ALDERLEA T6 Installation & Operation Manual - Baffle Removal
15
170314-20 AL6B
Chimney connector pipe should be disconnected from stove to clean and inspect.
Only if this is not possible should you remove baffle assembly.
DO NOT OPERATE WITH BAFFLE ASSEMBLY OR INSULATION REMOVED.
Removal
Remove retaining pin located at the rear top of the fi rebox, just below the
baffle. Lift baffle up and pull forward to disconnect from the supply tube. Tilt baffle
sideways to drop down and remove from fi rebox. Inspect gasket between baffle and
supply tube. If necessary, replace with gasket SUMB.BAFGASK(5pcs.) available
from your Pacifi c Energy dealer. Re-install baffle assembly in reverse order. The
two side pieces of insulation must be tight against the siderails.
Secondary Air Box Removal and Cleaning:
1. The secondary air box is located on the bottom rear of the woodstove and can
be cleaned by removing the two screws securing the cover plate on the rear
face of the secondary air box and using a vacuum to suck out any debris.
2. To remove the secondary air box, use a 10mm wrench and undo the two #10
Keps nuts, one on each side of the secondary air box. Lower the secondary
air box and slide out.
3. Reverse this process to re-install the secondary air box.
*
MAKE SURE THE GASKET IS IN GOOD SHAPE AND POSITIONED
CORRECTLY.
Baffle Removal
Disposal of Ashes
Ashes should be placed in a metal container with a tight fi tting lid. The closed container of
ashes should be placed outside on a non-combustible fl oor or on the ground, well away
from all combustible materials, pending fi nal disposal. If the ashes are disposed of by burial
in soil or otherwise locally dispersed, they should be retained in a closed container until all
cinders have thoroughly cooled. Other waste should not be placed in this container.