Pacific Energy PACIFIC INSERT Installation And Operating Manual - page 3
3
6.5"
24"
20.5"
2"
16"
Safety
READ ALL INSTRUCTIONS BEFORE INSTALLING
AND USING THIS APPLIANCE.
We strongly recommend that smoke detectors be installed. If
smoke detectors have been previously installed, you may
notice that they are operating more frequently. This may be due
to curing of stove paint or fumes caused by accidentally
leaving the fire door open. Do not disconnect the detectors. If
necessary, relocate them to reduce their sensitivity.
SAFETY NOTICE: If this stove is not properly installed, a
house fire may result. For your safety, follow the installation
directions. Consult local building or fire officials about restric-
tions and installation inspection requirements in your area.
The services of competent installer, certified by the Wood
Energy Technical program (WETT) - in Canada, Hearth
Education Foundation (HEARTH) - in U.S.A. (or equivalent)
are strongly recommended.
Clearances
Masonry or Factory Built Fireplace
The minimum required clearances to surrounding combustible
materials when installed into a masonry or factory built fire-
place are listed below and in figure #1.
Minimum Clearances to Combustibles
(Measured From Insert Body)
Adjacent Sidewall ......................... 20.5 in.
(520 mm.)
Mantel .............................................. 24 in.
(610 mm.)
Top Facing ....................................... 24 in.
(610 mm.)
Side Facing (1.5 in. extension) ....... 6.5 in.
(165 mm.)
Fig. # 1
Mantel or Top Facing
Side Facing
Fireplace
Hearth
Adjacent Wall
Fireplace Hearth: The non-combustible fireplace hearth must be raised 2" above an adjacent combustible floor and
extend 16" in front and 8" beyond each side of the existing fireplace opening. Additional ember protection will be
required. A non-combustible hearth that extends a minimum 23-1/2" in front of the fireplace opening may be flush to
an adjacent combustible floor.
Ember Protection: Combustible floor in front of the fireplace insert must be protected from hot embers by non-
combustible material extending 16" to the firing side and 8" to the other sides of the fireplace insert.
*
*
*