Pacific Proteus 210E Operating & Maintenance Instructions - Daily Machine Maintenance
Page 11 of 14
DAILY MACHINE MAINTENANCE
CLEANING THE SQUEEGEE
To obtain the best drying results, keep the
squeegee clean.
To clean the squeegee it is
necessary to:
22) Remove the vacuum hose from the
squeegee.
23) Loosen the knobs (1).
24) Clean the inside of the squeegee thoroughly.
25) Clean the squeegee blade thoroughly.
26) Reassemble.
REPLACING THE SQUEEGEE BLADES
Check the squeegee blades for wear and if
necessary, change them.
To replace the
squeegee blades:
27) Remove the squeegee vacuum hose from its
port.
28) Remove the locking pin from the stud bolt.
29) Remove the squeegee from its support.
30) Loosen the wing nuts (1) that lock the rubber
blades and take them off.
31) Replace the blades.
32) To reassemble the squeegee, repeat the
above operations in reverse.
BRUSH / PAD DRIVER REMOVAL
To remove the brushes / pad drivers:
33) Lift the brush base with the foot pedal.
34) Turn off brush switch (1).
35) Rotate each brush until they come off the
brush plate. The lower right figure shows the
direction for releasing the right brush. Rotate
in the opposite direction to release the left
brush.