Wet/dry vacuum wdv-18 operating manual read this manual carefully and keep it near the machine, protected from liquids and other damaging substances. Failure to follow the instructions may result in injury or damage to equipment and property. Carefully inspect all components for freight damage. If s...
2 12/1/2017 specifications 1. Overall machine units weight 69 lbs dimensions width at body 18 inches width at squeegee 24 inches length 28 inches height 38 inches noise 79 dba 2. Wheels type and dimensions rear wheels 10 inches front caster 3.5 inches 3. Recovery tank capacity 18 gal draining drain ...
3 12/1/2017 table of contents section page # 1. Safety instructions 4 o grounding 5 o extension cords 6 o lifting and transportation 7 o preparation 7 2. Squeegee 8 3. Draining the machine 10 4. Cover assembly 11 5. Optional dry filter 12 6. Wiring diagram 12 7. Maintenance 13 8. Troubleshooting 13 ...
4 12/1/2017 1. Important safety instructions when using an electrical appliance, basic precautions should always be followed, including the following: read all instructions before using vacuum cleaner warning: to reduce the risk of fire, electric shock, or injury: do not leave appliance when plugg...
5 12/1/2017 grounding instructions this appliance must be grounded. If it should malfunction or break down, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment-grounding conductor and grou...
6 12/1/2017 using extension cords the machine comes standard with a 50 foot, 16 gauge, 3 conductor cord (50’ 16/3 awg). Do not use an extension cord in conjunction with the cord provided with the machine. Replacement cords must meet or exceed the specification of the original cord. Warning: do not u...
7 12/1/2017 lifting and transportation caution: two person lift. Never attempt to lift the machine alone. unplug the cord and wrap it securely around the handle secure the machine with straps during transport in a vehicle or trailer to prevent damage preparation verify the facility and the mac...
8 12/1/2017 2. Squeegee remove and install the squeegee head: use the two black center knobs to remove and install the squeegee assembly from the machine. Remove and install the squeegee blades: note: the squeegee blades can be used twice by flipping them over to the other edge. Installation is the ...
9 12/1/2017 raise and lower the squeegee assembly: move the foot lever forward and allow the squeegee assembly to lower to the working position press the foot lever down and back to lock the squeegee assembly to the up position raise lower.
10 12/1/2017 3. Draining the machine note: the vacuum must be turned off prior to draining the machine. Drain hose: 1. Back the machine up to the drain 2. Lift the drain hose from the holster 3. Remove the drain cap 4. Lay the hose into the drain 5. Replace the cap when finished drain spout: 1. Remo...
11 12/1/2017 4. Cover assembly open to open the cover assembly release the latch on the front of the machine and rotate the cover backwards until it stops. Close rotate the cover forward, verify it is properly seated on the tank, and secure the latch to the catch on the tank. Removal 1. Secure the e...
12 12/1/2017 5. Dry filter the optional dry filter is installed over the ball float. The dry filter must be removed for wet recovery. Note: once the mount bracket is installed it does not need to be removed again. 1. Use the 2 screws and lock washers and install the bracket as shown 2. Slide the fil...
13 12/1/2017 7. Maintenance * read all safety instructions prior to performing maintenance warning: always unplug the cord from the power outlet before performing any service, maintenance, or inspection of the machine. 1. After each usage: inspect cords, switches, caster and wheels for wear clea...
14 12/1/2017 9. Parts diagrams cover assembly it em q ty p a r t nu m b er d es c r ipt io n 11 69 23 01 c o v er t a n k w d v 2 1 69 23 02 c o v er m o to r v a c u u m 3 4 96 22 63 sc r ew , b u tt , s o c k , . 25 ‐2 0x .6 2, s s b o 4 1 695 201 m o to r v a c uum 1 20v a c 5 1 603 473 g a sk et...
15 12/1/2017 it em qt y p a r t n u m b er d es c r ip ti o n 1 1 698601 ta n k r ec o v er y w d v 2 1 694101 h o se d r a in w d v w it h c a p 3 1 692002 c la m p h o se p la st ic 1 .69‐ 1. 81 d ia 4 1 696801 p lu g d r a in h o le 2 in c h 5 4 w 189d sc r ew , h ex , 1/ 4‐ 20 x .75, s s, p a tc...
16 12/1/2017 it em q ty p a r t n u m b er d es c r ip ti o n 1 1 693202 fr a m e sq ue eg ee w d v 2 1 697201 r et a in er b la d e sq u ee g ee 3 2 690701 b la d e sq ue eg ee 2‐ ed g e w d v 4 1 694102 h o se s q u ee g ee w d v 5 2 695001 k n o b r et en ti o n s q u ee g ee 6 2 695005 k n o b r...
17 12/1/2017 it em q ty p a r t n u m b er des c r ip ti o n 1 1 6932 01 fr a m e li ft s q u ee g ee 2 1 6908 02 b r a c k et l if t sq u ee g ee 3 3 9622 38 sc r ew s h ld r .38” d ia . X .25” l x .31‐ 18 4 3 6911 01 b u sh in g sp li t .3 8 in c h 5 1 9200 36 n u t, n yl o c k , 5 /16‐ 18 , s s 6...
18 12/1/2017 optional accessories kit it em q ty p a r t n u m b er des c r ip ti o n 1 695 00 4 k it , a c c es so r ie s 1 1 69 33 05 fo a m , f il te r k n o c k d o w n 2 2 98 00 02 lo c k w a sh er 32 w 16 9d 1/ 4‐ 20 h ex c a p s c r ew 4 1 69 08 01 b r a c k et , f il te r r et a in er 5 1 69...
19 12/1/2017 10. Warranty policy the pacific wet/dry vacuum wdv-18 has been manufactured, tested and inspected in accordance with specific engineering requirements and is warranted to be free from defects in workmanship and materials as follows: ten (10) years parts, one (1) year labor - polyethyl...
20 12/1/2017 http://www.Pacificfloorcare.Com/.
