Summary of Daytona
Page 1
Packard bell daytona disassembly manual.
Page 2: Table of Contents
1 table of contents overview 2 technician notes 2 disassembly instructions 2 reassembly instructions 2 required tools 2 hazardous voltage 3 avoid electrostatic discharge 3 power supply unit 3 removing the front bezel 4 removing the left side cover 4 removing the right side cover 4 removing the dvd/c...
Page 3: Overview
2 overview this document contains step-by-step disassembly instructions for the daytona chassis. The instructions are illustrated where necessary with images of the part that is being removed or disassembled. Furthermore, the screws that are removed are shown next to the image of the parts themselve...
Page 4: Hazardous Voltage
3 hazardous voltage there is hazardous voltage present inside the computer when it is connected to an ac supply, even when the computer’s power switch is off. Exposure to hazardous voltage could cause personal injury. To avoid risk of injury, contact an authorized service provider for proper (un)ins...
Page 5: Removing The Front Bezel
4 removing the front bezel to remove the front bezel, do as follows: 1. Turn off the computer, the monitor and all peripheral devices. 2. Disconnect all power and data cables connected to the computer. 3. Face the front of the unit. 4. Locate a handhold under the chassis. 5. Carefully pull the front...
Page 6
5 1. Remove the two screws that hold the right side cover. Fig. 3: removing the right side cover screws 2. Carefully slide the side cover two centimetres towards the front of the chassis. 3. Lift the side cover out and away from the chassis. Fig. 4: removing the right side cover removing the dvd/cd-...
Page 7: Removing The Hard Disk Drive
6 fig. 5: removing the dvd/cd-rom drive screws 3. Slide the drive towards the front out of the bay. Removing the floppy disk drive to remove the floppy disk drive, first remove the front bezel (see section removing the front bezel), remove the left side cover (see section removing the left side cove...
Page 8: Removing Add-In Cards
7 1. Carefully disconnect the four-wire power cable and the flat data interface cable from the hard disk drive. Fig. 7: disconnecting cables from the hard disk drive 2. Support the drive to ensure it does not fall. 3. Remove the screws securing the internal 3.5-inch hard disk drive to the chassis. F...
Page 9
8 fig. 9: removing the front usb port 2. Extract the white connector to disconnect the usb cable from the usb port. 3. To remove the usb cable also, disconnect the usb cable from the motherboard and remove it from the chassis. Fig. 10: disconnecting the front usb port cable removing the switch/led a...
Page 10: Removing The Power Supply
9 fig. 12: disconnecting the switch/led assembly cable 4. Gently pull away the cable and the switch/led assembly from the chassis. Note: when reassembling the switch/led assembly, take care that you return it to its original position, i.E. With the switch at the top and the leds at the bottom. Remov...
Page 11: Notice
10 notice the information in this guide is subject to change without notice. This guide contains information protected by copyright. No part of this guide may be photocopied or reproduced in any form or by any means without prior written consent from nec computers international bv. Nec computers int...