Pacvac Superpro 700 Product & Training Manual - page 5
www.pacvac.com
Support: 08 9479 1444
6
7
5. Operate Right
How to vacuum easier and faster with no back strain:
1. Stand upright, with the bent hand piece section parallel to the floor.
2. Hold the bent hand piece with one hand at a comfortable arm’s length.
3. Move forward and away from the power point.
4. Use easy underarm swinging motion when detail cleaning and short dabs when spot cleaning,
always standing upright.
5. Once the end of the power cord has been reached and work completed, return to the
power point along the power cord line and disconnect the power cord from the power point.
6. If work not completed move to the next area, connect power cord to the nearest power point
and repeat steps 1 through 6.
7. If work completed disconnect power cord from power point then wind from the back pack
towards the end of the power cord to reduce likelihood of cable twists, fractures and knots.
8. Remove back pack by sliding the left strap off the shoulder, while raising right arm/shoulder
to hold strap in place. Slowly lower the right shoulder and lower the back pack to the floor.
Do not drop.
6. Work Right
lOOk aT THE layOuT (refer to the fishbone Method below)
1. Find the most easily located power point. This is your starting location at the fish’s head.
Your turnaround is the ‘tail’.
2. Check the room layout (position of desks, tables, chairs, fittings etc.)
3. Check the condition of the floor - how dirty it is on a scale of 10.
Plan THE PROCESS
1. See in your mind the fishbone method over the entire area or room to be cleaned.
2. Decide which areas are to be detail cleaned (the spine), or spot cleaned (the ribs).
ClEan SMaRTER
1. Work away from the power point.
2. Work one side of the fishbone towards tail. Then back the other side towards head.
3. Work to the plan - long strokes for the detail clean area and short dabs for the spot cleans.
4
6
1
2
3
4
fishhead Start
Spine Heavy Traffic Areas - Detail
Ribs Light Traffic - Spot
Tail Turnaround