PageFlip Lite User Manual - page 10
PageFlip Lite User Guide
4.7
Setting Up the Book Holder
4.7
Setting Up the Book Holder
The bookholder consists of a back support and two spring-loaded arms (Fig. 6(a)). Each arm
has a tip that includes a page restraint to block loose pages from turning freely. In addition, the
arms have two pegs that snap into rear slots on the PageFlip Lite to secure the book holder
into place, as shown in Fig. 4(c) and Fig. 6(b). If you find the book holder already mounted into
the rear of the page turner (Fig. 7) or Fig. 4(c)), pull the book holder upward and out.
1. Secure the book holder to the bottom edge of an open book. This is done by pulling
the page restraints away from the supporting plate. An open book is slid into the space
between the flexed arms and the supporting plate. Release the arms, allowing the com-
pressive force of the springs to secure the book between the page restraints and the
supporting plate.
2. Slide up to ten sheets out from under the page restraint. These pages will be free to
turn.
(a)
(b)
Figure 6: (a) Front and (b) rear view of book holder, whose pegs snap into rear slots on unit.
Figure 7: PageFlip Lite with mounted book holder.
PageFlip, Inc.
10
www.pageflip.com