PagePac V-5330120 Installation manual - Surface Mounting
3
947179
PIPE OR CONDUIT
WALL
SURFACE
BRACE
MOUNTING SCREWS
GANG BOX
1
B Another method to attach the
gang box to the surface of a wall,
which is more secure and
provides
.
an esthetically pleasing
look, is to drill mounting holes (4)
directly into the back of the gang box.
Using the appropriate screws
(depending on the material the wall
surface is made of) position the
screws through the inside of the gang
box and using a screwdriver secure
the gang box to the wall. Once the
gang box has been properly braced,
install the speaker unit and face plate
as shown in illustrations 4 and 5.
A The gang box mounting
brackets (included) can be screwed
to the gang box back plate so they
protrude out the sides of the gang
box. Using the appropriate screws
(depending on the material the wall is
made of), position the screws through
the bracket holes and using a
screwdriver secure the gang box to
the wall surface. Once the gang box
has been properly braced, install the
speaker unit and face plate as shown
in illustrations 4 and 5.
GANG BOX
MOUNTING
BRACKETS
NOTICE:
—All conduit and
closure plug
connections
should be
adequately sealed
(i.e., pipe joint
compound) for wet
location
installations.
—Do not allow
conduit to
protrude into rear
opening of outlet
box to avoid
interference with
Door Speaker.
FLUSH MOUNTING...
go to step 2.
SURFACE MOUNTING
—The gang box
should be
grounded via the
conduit to a
suitable earth
ground to provide
protection against
lightning strikes.
CAUTION : SEAL TOP PLUG
WITH OUTDOOR SEALANT
SUCH AS SILICONE RUBBER
WEATHER RESISTANT
DOUBLE-GANG OUTDOOR
ELECTRICAL BOX
(PROVIDED)