PagePac V-5330120 Installation manual - Flush Mounting
4
947179
FLUSH MOUNTING
W
A L L S U R F A C E
B R A C E G A N G
B O X T O S T U D
S T U D
S T E E L D O U B L E -
G A N G I N D O O R
E L E C T R I C A L B O X
2 "
RUNNING WIRES
1
2
3
4
S P E A K E R
L U C E N T T E C H N O L O G I E S
D O O R S P E A K E R
2 4 A W
G S H I E L D E D T W
I S T E D P A I R C A B L E
D O N O T C O N N E C T S H I E L D
T O S P E A K E R S I D E
D O O R B E L L /
C H I M E B U T T O N
C O N T R O L U N I T
D O O R
S P E A K E R
O U T P U T
D O O R B E L L
B U T T O N
T E R M I N A L S
A U D I O P A I R
C O N T R O L P A I R
N O T E : S E E S T E P 4 F O R S P E A K E R H O O K U P
from the control unit, along with the push-
button wires, to the installed double-gang
electrical box. Keep track of which colored
wire is connected to which device. Route wires
through conduit (if necessary) and feed into
double-gang outlet box.
Check National Electrical Code and
applicable local codes and ordinances for
exact wiring requirements for your area.
3
Run the twisted pair wires
are often desirable because mounting hardware and wires are
hidden inside the wall. Steel double-gang indoor electrical
boxes mount directly to a stud. Once the gang box has been
properly braced to a stud, install the speaker unit and
faceplate as shown in illustrations 4 and 5.
Note: Electrical box must be at least 2 inches deep to
accommodate door speaker.
Flush-mount surface installations
Cut wires, leaving six (6) extra inches for connection to Door
Speaker’s terminal strip. Strip approximately 1/2 inch off one
end of each of the four wires.
The shield is not connected to any part of the speaker or gang
box. The shield is only connected at the Controller terminal
labeled “shield.”
Total length of wire from control unit to door speaker should
not exceed 1500 feet.
2