Quick start guide rk-1 high throughput - dual wan, gigabit audio/video router version 1.0 pakedgedevice&software inc.
2 contents overview 3 package contents 6 installing the router 6 changing the router password 7 accessing the router gui 7 connecting to the internet 7 changing the lan ip 12 troubleshooting and support 14.
3 overview the rk-1 is an high power audio/video router that is designed to minimize installation times through an intuitive gui. See the table 1 for more information..
4 table 1: led explanation (from left to right) note: lan port number 5 can be configured as a guest network. Please see the user’s manual for additional information. Led status operation usb 1 - 2 link/ act blue usb is connected flashing blue usb is being accessed off no device connected wan 1 - 2 ...
5 you will find a description of the interfaces on the back of the rk-1 in table 2 . Table 2: interface explanation (from left to right) interface type speed protocol description reset button n/a n/a n/a hold reset button for 10 seconds to factory default the settings usb 1 - 2 usb-a 5gbps usb 3.0 u...
6 package contents rk-router mounting brackets power cable 1ft cat5e cable quick start guide installing the router 1. If mounting the router in a standard 19” av rack, attach the rack- mounting brackets that come with the router to the sides. If not rack- mounting, ensure that the router is physical...
7 changing the router password it is strongly recommended that you change the default password for the router. Please refer to the user manual for step by step instructions. Accessing the router gui 1. Make sure your network card is set to obtain an ip address automatically. Then open any internet b...
8 determine what type of internet connection you have from your internet service provider (isp), and then follow one of the three instruction sets below to connect the router to the internet. Dhcp: by default, the router will connect to the internet using dhcp. If your isp uses dhcp, you may need to...
9 2. Click on edit under wan zone. 3. Select static address for the protocol..
10 4. Click on switch protocol. 5. Enter the ip address from your isp. Select the appropriate subnet mask from your isp. You can select custom to enter a custom subnet mask. Then enter your default gateway and dns server. Leave the override mac address at default. Click apply. The router now has the...
11 pppoe: to configure the router using a pppoe connection, you will need to complete the following steps: 1. Hover your mouse towards the top of page to see the menu. Click on network zones. 2. Click on edit under wan zone. 3. Select pppoe from the protocol drop down menu. Then click on switch prot...
12 4. Enter the username that the isp assigned under the pap/chap username field. Enter the password in the pap/chap password field. Click apply when finished. The router is now setup for pppoe. Changing the lan ip the default ip address of the router is 192.168.1.99. If you need to change the ip ad...
13 2. Click edit under lan zone. 3. Enter the new ip address you wish to use in the ip address field. In the following example we change the ip address of the router to 192.168.1.1. 4. Click apply towards the bottom to finalize the settings..
14 troubleshooting and support if you are unable to get the router functional using these steps, you can refer to the full manual on our website or contact the technical support team for assistance. Contact information website: www.Pakedge.Com email: support@pakedge.Com phone: (650)385-8703 © pakedg...
