Pakedge SW24-24PB Web Management User Manual - page 17
Web Management User Guide
- 15 -
In page configuring process, at least one Trunk has been established then polymerization
settings can take effect; configured Trunking method is also applied to all on the Trunk groups;
in that already exist on the Trunk can add or remove Port members ; in the absence of the port
members situation can deletee a Trunk Group.
Switch provides three kinds of port trunking methods: Based on the source MAC
address, based on the purpose MAC address, based on the source and purpose MAC
addresses.
Switch switch maximum support 3 groups port trunking, can be configured to a maximum of
three Trunk Group, Trunk1 and Trunk2 can not trucking Gigabit ports, and each group can be
aggregated up to the same four attributes port. Trunk3 only be aggregated Gigabit ports, and up
to 2 Gigabit ports can be aggregated. Port aggregation method is common to all of the Trunk.
Figure 24 Port Trunking configuration page
(9)
Port mirroring configuration page
Figure 25 is the port mirroring configuration page .the page allows users to configure port
mirroring. Port mirroring through the mirror port to monitor the data packets of being mirrored
output port and the data packets of being mirrored input port.. mirroring Port can only choose
one, being mirrored output port and being mirrored input port can select multiple. This page
consists of four components: monitor port, configurable port, monitoring tdirection and mirror
configuration information. When you start to configure a mirror port ,firstly configured mirroring
port from monitor ports, mirror ports can only have one, and then select the mirror port from the
configurable port, select the monitor direction, and press the application key to entry into force,
the results is displayed in the mirrored configuration information.
When choose the RECEIVE in direction of monitor, said monitor data packets received,
TRANSMIT, said monitor data packets sent, BOTH that monitor all data sent and received
packets, NOT_RECEIVE to cancel monitoring received data packets, NOT_TRANSMIT to
cancel monitor send data packets, NEITHER cancels monitor data packets received and sent,
that is canceling monitor port.