Palatinco Split Type Owner's Manual - page 6
4
OPERATING TEMPERATURE
Temperature
Mode
Cooling operation
Heating operation
Drying operation
Room temperature
17 C 32 C
0 C
3 0 C
17 C 32 C
18 C
43 C
11 C 4 3 C
( -5 C
43 C:For the models with
low temperature cooling system)
Outdoor temperature
( 21 C
52 C:For special tropical
models)
-7 C
24 C
21 C
52 C (For
special tropical
models)
CAUTION:
1. If air conditioner is used outside of the above conditions, certain safety protection
features may come into operation and cause the unit to function abnormally.
2. Room relative humidity less than 80%. If the air conditioner operates in excess of this
figure, the surface of the air conditioner may attract condensation. Please sets the vertical
air flow louver to its maximum angle (vertically to the floor), and set HIGH fan mode.
3. Optimum performance will be achieved within these operating temperature.
MANUAL OPERATION
Manul operation can be used temporarily in case you can not find the remote controller or
its batteries are exhausted.
Manual
control button
Manual
control button
AUTO/COOL
AUTO/COOL
1
Open and lift the front panel up to an angle until
it remains fixed with a clicking sound.
2
Push the button until the AUTO indicator is lit,
the unit will work in forced AUTO mode (the
default setting temperature is 24 ).
3
Close the panel firmly to its original position.
CAUTION:
Once you push the manual button, the operation
mode is shifted in an order as: AUTO, COOL, OFF.
Push the manual button until the OPERATION
indicator flashes rapidly (five times per second),
the unit now is operating in forced COOL
mode. This is used for testing purposes only,.
(For 16000Btu/h Models)
Manual
COOL
When the OPERATION indicator goes off, the
air conditioner is OFF.
To restore the remote controller operation, use the
remote controller directly.
control button
AUTO
Manual
COOL
1
Open and lift the front panel up to an angle
until it remains fixed with a clicking sound.
2
Push the AUTO button and the airconditioner
will run in AUTO mode.
3
Close the panel firmly to its original position.
control button
AUTO
NOTE:
The "COOL" mode on the control board is only
(For 16000~21000Btu/h Models)
provided for testing purposes.