PaloAlto Networks PA-2000 Series Hardware Reference Manual - Chapter 2
Palo Alto Networks
Installing the Hardware • 9
July 17, 2015 - Palo Alto Networks COMPANY CONFIDENTIAL
Chapter 2
Installing the Hardware
This chapter describes how to install the PA-2000 Series. For more information, refer to the
following topics:
•
“Tamper Proof Statement” on page 9
•
“Before You Begin” in the next section
•
“Equipment Rack Installation” on page 10
•
“Connecting Cables to the Device” on page 11
•
“Connecting Power” on page 11
Tamper Proof Statement
To ensure that products purchased from Palo Alto Networks have not been tampered with
during shipping, verify the following upon receipt of each product:
•
The tracking number provided to you electronically when ordering the product matches
the tracking number that is physically labeled on the box or crate.
•
The integrity of the tamper-proof tape used to seal the box or crate has not been
compromised.
•
The warranty seals on the device itself do not show evidence of tampering.
Before You Begin
•
It is recommended that two people be available to mount the PA-2000 Series in a 19-inch
rack.
•
Have a Phillips head screwdriver available.
Note:
The PA-2050 and PA-2020 firewalls are collectively referred to as
the PA-2000 Series.