Paloform CIR-18 Installation Manual - page 4
4
MISO FIREBOWL | Owner and Installation Manual
1. Please refer to ‘Clearances to Combustibles’ guide on page 6 of this guide for placement.
2. Ensure that the final location for the fire pit is as flat and level as possible. Also provide adequate drainage
beneath the opening in the base of the fire pit body.
3. Completely unpack the fire pit.
4. Remove Burner Assembly (1) and Topping Ring from fire pit body and carefully set aside.
5. Carefully lift the fire pit and place it in its final position. If there is a gas riser, fire pit vessel should be placed
so that the stub is enclosed within the fire pit body (3).
6. If the fire pit does not sit level, shim appropriately so that it is level and evenly supported.
7. Connect to Natural Gas or Propane Source as per page 8 of this manual.
8. Assemble Burner as per instructions on page 7.
9. Check for leaks and test burner (see page 8).
10. Remove Control Knob (4) and stem from valve assembly. Align valve with Control Knob hole. Place Burner
Assembly into Body. Visually check to ensure that the valve is aligned with the hole.
11. Push Control Knob (4) back into valve. The Knob should fit tightly.
12. Place Topping Ring over Burner Assembly and cover with Decorative Topping media as per instructions on
page 7.
CAUTION:
HEAVY: Use care
when lifting and
placing to avoid
injury and damage
to property and the
fire pit itself. Fire pits
will require 2 or more
people to lift.
ATTENTION: Fragile! Concrete may chip or scratch if collided with other hard
materials such as stone, metal, or other concrete. HANDLE WITH CARE!
PLACEMENT AND ASSEMBLY