Paloform CIR-18 Installation Manual - page 7
7
MISO FIREBOWL | Owner and Installation Manual
WARNING:
Failure to position parts in
accordance with these diagrams
and instructions and/or failure to
use parts specifically approved
for use with this appliance may
result in property damage or
personal injury.
CAUTION:
Do not remove the metal data
plates attached to the Outdoor
Fire Pit Burner. These plates
contain important information.
NOTICE:
Installation and repair should
be done by a qualified service
person. The appliance should
be inspected before use and at
least once annually by a qualified
service person. More frequent
cleaning may be required as
necessary. It is imperative that
control compartment, burner and
circulating air passageways of
the appliance be kept clean.
BURNER ASSEMBLY
TO ASSEMBLE THE BURNER
1. Connect the Burner Assembly to the gas/propane supply
using the supplied flex connector and following the
instructions on page 8.
2. Carefully leak test all connections following the procedure
on page 8.
3. Fill the burner pan evenly with burner media (crushed
glass for NG, lava rock for LP) fully covering burner ring.
Media should be level with the top rim of the pan. Do not
obstruct lighting port with burner media!
4. Follow the Initial Lighting Instructions on page 10.
Make sure that the flame carries to all parts of the
burner. Turn OFF the appliance and let it cool before
proceeding to the next step.
5. Replace Topping Pan. Place and evenly distribute
decorative topping (river stones, crushed glass or lava
rock) on top of burner media. An uneven or excessively
thick layer of topping can result in an uneven flame.
6. Do not cover pilot shield. Keep the lighting port open
and free of media. Do not use any media not supplied
by the manufacturer!
LIGHTING PORT