Paloform ROBATA 54 CORTEN FIRE Installation Manual - page 8
8
ROBATA 72/54 CORTEN FIRE | Owner and Installation Manual
TO ASSEMBLE THE BURNER
1. Remove the Burner Assembly and Burner Media from packaging (see Parts List on page 16).
2. Connect the Burner Assembly to the gas supply using the supplied flex connector and following the
instructions on page 7.
3. Carefully leak test all connections following the procedure on page 7.
4. Fill the burner trough evenly with burner media (NG - crushed tempered glass; LP - volcanic rock). Do not
obstruct the pilot ignition port with burner media! Do not use media not supplied by Paloform!
5. Place the burner assembly on a stable surface. Ensure burner is level.
6. Follow the Initial Lighting Instructions on page 10. Make sure that the flame is even along the burner
length and appliance is fully operational and safe for use. Turn OFF the appliance and let it cool before
proceeding to the next step.
7. Carefully lift the burner and place it in the Robata body. (See page 5)
8. Place and evenly distribute decorative topping media (lava rock or tempered glass pebble) on top of burner
media. Completely fill topping receptacle. Decorative media can be brought level with the top of the pilot cover.
Do not obstruct PILOT IGNITION PORT!
WARNING:
Failure to position parts in
accordance with these diagrams
and instructions and/or failure to
use parts specifically approved for
use with this appliance may result in
property damage or personal injury.
Do not remove the metal data
plates attached to the Outdoor Fire
Pit Burner. These plates contain
important information.
NOTICE:
Installation and repair should be
done by a qualified service person.
The appliance should be inspected
before use and at least once annually
by a qualified service person. More
frequent cleaning may be required
as necessary. It is imperative that
control compartment, burner and
circulating air passageways of the
appliance be kept clean.
CAUTION:
New Lava Rock may pop or crackle
when first heated. This should
subside after 30 minutes to one hour
or more of operation. Maintain safe
distance during this time.
BURNER ASSEMBLY
PILOT IGNITION PORT