Palstar VHF-1200 Owner's Manual - page 8
8
CAUTION:
•
DO NOT attempt any type of service or repair on this amplifier without first removing the
AC power and allowing
AT LEAST 60 MINUTES FOR THE HIGH VOLTAGE CAPACI-
TORS TO BLEED OFF !
•
DO NOT operate this amplifier with the top or bottom covers removed. DO NOT operate
this amplifier with the internal RF tube compartment covers removed. Never place any ob-
jects into the top ventilation holes.
CONTACT WITH VOLTAGES IN THE CABINET
CAN BE FATAL ! EXPOSURE TO UNSHIELDED RF AT THESE POWER LEVELS
IS HAZARDOUS TO YOUR HEALTH !
•
Never attempt operation without first connecting an appropriate antenna (2:1 VSWR Max)
or a 50 ohm dummy load with sufficient rating or
SERIOUS DAMAGE TO THE AMPLI-
FIER MAY RESULT.
•
Never operate the amplifier with more drive than required to produce the rated output for
the operating mode used.
•
Do not place the VHF-1200 OR VHF-2000 in repeater operation. These amplifiers are not
designed for unattended service.Never operate any amplifier using an extension cord.
•
Never cover the top of the amplifier cabinet with books, papers or other equipment a
s
OVERHEATING MAY RESULT.
FOR ASSISTANCE CONTACT THE MANUFACURER:
Telephone: 800-773-7931
International: 937-773-6255
E-mail: info@palstar.com
!! WARNING !!
CONTACT WITH VOLTAGES IN THIS AMPLIFIER CAN BE
!!! FATAL!!!