Panamorph Paladin Installation Manual - page 4
Panamorph Paladin and Phoenix Lens Installation Guide, V1.4 Page | 4
3. Attach the Lens to the Lens Bracket by inserting the four #8-32 Bracket Screws (two
on each side) through the Lens Bracket height-adjustment ratchet slots and into the
Bracket Arms.
4. Refer to instruction illustrations for your particular Attachment Kit. Attach the Lens
Bracket (now with Lens attached) to the Attachment Plate by directing the Bracket
Attachment Screws (now in the Lens Bracket) up through the slotted holes (XM2) or
the horizontal slot (XMU/XMU-S) and secure using the two Thumb Knobs. NOTE: If
the longer 1 5/8” Bracket Attachment Screws are used then the 1” Bracket
Attachment Spacer should be between the Lens Bracket and the Attachment Plate.
If using the XMU or XMU-S Plate, loosen the Thumb Knobs and slide the Lens
Bracket horizontally in the slot to center the Lens in front of the projector lens before
retightening the Thumb Knobs.
5. Remove the protective film from the Lens. Turn on the projector and project a full
test image preferably with fine, white horizontal and vertical lines and observe the
beam passing through the Lens. Height adjustments are made by slightly loosening
the two Bracket Screws on each side and then tilting and vertically moving the
Bracket Arms attached to the Lens to an appropriate notch in the ratchet slots where
the Bracket Arms can settle to align with the sides of the Lens Bracket. Tilt
adjustments are made by slightly loosening the two Lens Tilt screws on each side
connecting the Bracket Arms to the Lens so that it pivots about the front screw. With
these operations in mind: