Panasat DSD 642 Operating Instructions Manual - page 20
20
OPERATING INSTRUCTIONS
DSD 642
NOTE:
The menu structure is occasionally upgraded over
the air by the Service Provider and may differ
slightly from that shown in these instructions.
U
SING
M
ENUS
To use the Menu system:
1
Ensure that the decoder is not in standby mode by
pressing
, if necessary.
2
Press TV on the RCU. The following window is displayed in the
top right of the TV:
Highlight
the selected
option then press OK.
This selection sets the services available in the subscribed
bouquet, which can be viewed by pressing TV GUIDE.
3
Press MENU on the RCU. The following Main Menu is displayed,
which provides access to all other menus as shown in the
following figure:
All the menus are navigated as follows:
1
Use
>
or
?
buttons to scroll the highlighted bar up or down in a
(sub)menu or a vertical list box.
2
Select a highlighted menu option and go one level lower within the
menu hierarchy by pressing OK on the RCU. This applies to the
Main Menu screen and all submenu screens.
In screens where parameters can be set, OK is used to save the
settings.
3
Use EXIT to return to the preceding menu (go one level higher
within the menu hierarchy).
In screens where the parameters can be set, EXIT is used to
cancel any settings that may have been entered without saving.
4
Use
=
and
<
buttons to change the value of an input field having
preprogrammed values.
5
Use MENU to exit all menus and return to the TV or audio
programme.
6
Use numbered buttons to enter numerical values.
Soundtrack Options
Soundtrack Options allows users to set the programme language of the
decoder, where one is available.
To select the text language of your choice do the following:
1
Press MENU on the RCU.
The Main Menu options list is displayed.
NOTE:
On initial selection of the Main Menu, the default
setting is for Soundtrack Options.
2
Press OK to select Soundtrack Options. The following option list is
displayed:
3
On the RCU, press
>
or
?
arrows to highlight the preferred
language that you wish to relocate from the list.
4
Press
<
to move the highlighted language option into the relocation
window.
NOTE:
Only two languages can be relocated into positions
1 and 2.
5
Press OK to confirm your selection.
NOTE:
Pressing
on the RCU displays the following
window at the top of the TV screen:
Pressing OK toggles between the two options. The programme
automatically returns to the previous service.