Panasonic CS-E12EKK Operating Instructions Manual - page 5
ENGLISH
5
AUTO
HEAT
FAN
SPEED
AIR
SWING
COOL
DRY
TEMP
AIR SWING
FAN SPEED
QUIET
POWERFUL
TIMER
ON
1
2
3
OFF
SET
CANCEL
MODE
OFF/ON
AC
RC
INVERTER
SET
CLOCK
CHECK
RESET
OFF/ON
TEMP
MODE
AUTO, HEAT, COOL, DRY
■
Operation Details
●
POWERFUL
and
QUIET
operations are available in all modes.
●
Press
OFF/ON
again to stop the operation.
Select the
desired
operation.
2
2
1
1
Start the
operation.
3
3
Set the
temperature.
(16°C ~ 30°C)
Troubleshooting
● Mist emerges from indoor unit.
► Condensation effect due to cooling process.
● Heating/Cooling does not work.
► Ensure temperature is set correctly.
► Make sure windows and doors are closed.
► Make sure filters are cleaned and replaced.
► Make sure inlet and outlet vents are cleared.
● Water flowing sound during operations.
► Cause by refrigerant flow inside the unit.
● The power indicator blinks during the operation and
the indoor fan is stopped.
► The unit is in defrost mode, and the melted frost is drained from the
outdoor unit.
AUTO - Automatic Operation
• Unit selects the operation mode
according to temperature setting,
outdoor and room temperature.
• The power indicator blinks during
operation.
• Operation mode is reselected
every 30 minutes.
HEAT - Heating Operation
COOL - Cooling Operation
• Enjoy cool air at your desired
temperature.
DRY - Soft Dry Operation
• Keeps your environment
dehumidified by running cooling
operation at a low fan speed.
■
Hint
• A temperature setting 1°C higher
in cooling operation or 2°C lower in
heating operation than the desired
temperature equates to a 10%
power saving.
• In heating mode, it takes a while
for the unit to warm up. The
power indicator blinks during this
operation.