Panasonic CS-ME10EB1E Operating Instructions Manual - page 8
8
CANCEL
OFF
TIMER
ON
TIMER
FAN
SPEED
AUTO
HEAT
DRY
COOL
OFF
MODE
TIMER
ON
OFF
CLOCK
RESET
SET
TEMP
POWERFUL
FAN SPEED
AIR SWING
OFF/ON
QUIET
AUTO
MANUAL
CHECK
INVERTER
CANCEL
TIMER
ON
OFF
CLOCK
RESET
SET
MANUAL
CHECK
C
CHECK
O
T
O
O
A
AI
IR
R
U
UT
T
O
O
T
C
CA
A
C
C
C
CH
HE
E
C
CK
HOW TO OPERATE
Timer
NOperation Details
• Use the ON timer to turn on the air
conditioner at the desired time. This
will give you a cooling or warming
environment, e.g. when you return
from work or wake up.
• When ON timer is set, operation will
start up to 35 minutes before the
actual set time.
• Use the OFF timer to stop the air
conditioner operation at the desired
time. This can save electricity while
you are going out or sleeping.
• The set timer will repeat daily once
it is set.
• If there is a power failure, you can
press SET button to restore the
previous setting once the power is
resumed.
• If the timer is cancelled, you can
restore the previous setting by
pressing SET button.
TIMER
L
Press CLOCK button more than 10 seconds to change the time format from 24 hours to AM/PM format.
L
For your convenience, you could set the air conditioner to operate automatically by using both ON and OFF timer.
Hints
Troubleshooting
L
TIMER indicator always on.
°
Timer is activated and the setting will repeat itself daily.
L
POWER indicator is blinking 60 minutes before ON
timer is activated.
°
The unit is determining the operation mode by sensing the room
temperature. This happens when it has been set to AUTO operation
mode.
L Ensure the clock on the remote control has been set
correctly.
L You could use the ON and OFF timers at the same time.
L To cancel either the ON or OFF timer, press
or
,
then press
.
• Where there is error, the unit stops
its operation and timer indicator
blinks.
1. Press for 5 seconds.
2. Browse for respective error code,
where “beep” sounds are heard.
3. Turn off the power supply and call
authorized distributor.
Note:
Press the “RESET” button to quit
checking.
Unit might be operated with limited
function depending on error found.
(Operation starts, 4 “beep” sounds are
heard.)
1
Select ON or
OFF timer.
2
Set the
desired time.
3
Confirm the
setting.
CANCEL
Cancel the
selected timer.