Panasonic CS-ME9SB4U Install Manual

Summary of CS-ME9SB4U

  • Page 1

    © panasonic corporation 2016 air conditioner indoor unit cs-me9sb4u destination usa canada please file and use this manual together with service manual for model no. Cu-2e18sbu, cu-3e19rbu, cu-4e24rbu, cu-5e36qbu order no. Papamy1604017ce, papamy1505100ce, papamy1312037ce. Op en cl os e cl os e op e...

  • Page 2: 11. Installation

    16 11. Installation instruction 11.1 attached accessories 11.2 indoor unit 11.2.1 selecting the location for the indoor unit provide a check port on the piping side ceiling for repair and maintenance. š install the indoor unit once the following conditions are satisfied and after receiving the custo...

  • Page 3

    17 6 the indoor unit must allow easy draining. 7 the indoor unit must allow easy connection to the outdoor unit. 8 place the indoor unit according to the height from the ceiling shown in the illustration below. 9 the indoor unit must be from at least 9.8 ft (3 m) away from any noise-generating equip...

  • Page 4

    18 positions of air conditioner body and ceiling surface 11.2.3 refrigerant piping refrigerant is charged to the outdoor unit. For details, see the manual for installation work of outdoor unit. (additional charging, etc.) 1 brazing for piping. A. Execute brazing before tightening the flare nut. B. B...

  • Page 5

    19 11.2.4 indoor unit drain piping š during drain piping connection, be careful not to exert extra force on the drain port at the indoor unit. š the outside diameter of the drain connection at the indoor unit is 1-1/4" (32 mm). Piping material: polyvinyl chloride pipe vp-25 and pipe fittings. š be s...

  • Page 6

    20 11.2.5 heat insulation be sure to perform heat insulation on the drain, liquid and gas piping. Imperfection in heat insulation work leads to water leakage. 1 use the heat insulation material for the refrigerant piping which has an excellent heat-resistance (over 248°f (120°c)). 2 precautions in h...

  • Page 7

    21 11.2.6 connect the cable to the indoor š open the control board cover by removing 2 pcs of screw. š unscrew and open the conduit cover upper case. Remove the plug and fix the conduit connector to conduit cover with lock nut. š connecting wire between indoor unit and outdoor unit should be ul list...

  • Page 8

    22 2 fitting the decorative panel o temporarily secure the fixing screws (3 pcs.) before fitting the decorative panel. (for temporarily securing the front grille.) o place decorative panel on the screws (3 pcs.) before fitting, move decorative panel as illustrated and tighten all the screws (4 pcs.)...