Panasonic DMP-BD60 - Blu-Ray Disc Player Service Manual

Panasonic DMP-BD60/BD80 

Region switching guide 

With the mod. chip fitted the player will automatically play DVD's from all regions (1-6), 

but for Blu-ray disc playback the region must be manually selected. 

Blu-ray Region switching is done using the player's original remote control while the 

player is in standby mode, by pressing the following buttons: 

'1' : Select Blu-ray region 'A' 

'2' : Select Blu-ray region 'B' 

'3' : Select Blu-ray region 'C' 

When the player is powered up out of standby mode the new Blu-ray region will be 

active. The selected Blu-ray region will remain active until the player is disconnected 

from mains power or a new region is selected while the player is in standby mode. 

Note that the player must fully enter standby mode to allow the mod. chip to change the 

Blu-ray region, therefore the player's "Quick Start" mode (which keeps the player fully 

powered up even in standby mode) must be disabled when changing Blu-ray regions. 

Blu-ray region switching is possible with any remote channel setting, 1, 2 or 3.