Panasonic KX-HNS101E Installation Manual - Testing The Window/
Testing the window/
door sensor
You can check the window/door
sensor’s LED indicator and test the
performance of the window/door
sensor.
1
Remove the sensor unit cover.
2
Press
M
N
on the sensor unit.
3
Open and close the window or
door several times.
R
Make sure that the LED
indicator lights in green when
you close the window or door.
4
Press
M
N
again.
Note:
R
If the LED indicator lights in red
when the window or door is closed,
the window/door sensor is not
installed properly. Re-evaluate the
position of the sensor unit and
magnet unit (page 13).
Features available
when using the
[Home Network] app
Some of the window/door sensor’s
features that are available when using
the
[Home Network]
app are listed
below. For more information, refer to
the User’s Guide (page 19).
–
Alarm system
You can use the app to arm and
disarm the alarm system, confirm
the current status of the sensor, and
view a log of previous events.
–
Sensor integration
You can configure the window/door
sensor to trigger other system
events, such as camera recording,
turning on an electric device (such
as a lamp), etc. (Appropriate device
required.)
–
Telephone alert
You can configure the system to call
a preprogrammed phone number
when the window/door sensor is
triggered.
Accessing the User’s
Guide
The User’s Guide is a collection of
online documentation that helps you
get the most out of the
[Home
Network]
app.
1
iPhone/iPad
Tap
in the app’s home screen.
Android™ devices
Tap or press your mobile
device’s menu button in the app’s
home screen.
2
Tap
[User’s Guide]
.
Note:
R
Microsoft
®
Windows
®
Internet
Explorer
®
8 and earlier versions are
not supported.
R
Android 4.1 or later versions are
recommended.
R
You can also access the User’s
Guide at the web page listed below.
www.panasonic.net/pcc/support/tel/
homenetwork/manual/
Helpline Tel. No.: U.K. 0330 3331112 Ireland 01 4475228
19
Appendix
HNS101E_(en_en)_0421_ver.060.pdf 19
2015/04/21 14:21:41