Panasonic MX-ZX1800 Operating Instructions Manual - page 5
EN8
EN9
English
Disassembly and assembly of the blender jug base
Before Use - Disassembly and Assembly -
Attach the jug base holder while aligning the ▲
marks on the blender jug base and jug base
holder. Then turn it anticlockwise firmly.
1
Pull out the jug base holder.
• Do not press tabs on the jug base holder
to avoid the blender jug base falling.
2
Tab
(Both side)
Press tabs on the jug base holder to release
the blender jug base from it.
3
Tab
(Both side)
1
Attach the jug gasket into the
groove on the bottom of the
blender jug.
(Failure to install the jug gasket
completely into the groove may
lead to leaking liquids.)
2
Attach the jug base holder while aligning the ▲
mark on the blender jug base and jug base
holder, then press the jug base holder until you
hear a click sound.
3
Insert the blender jug base into the blender jug
after aligning, then turn the jug base holder
clockwise until it stops turning. ( The “O” mark
on the blender jug base will align with the line
on the blender jug.)
4
Press tabs to remove the jug base holder.
Tab
(Both side)
●
Pay attention when handling the blender jug base. Blades are sharp.
●
If the gasket is not attached to blender jug and/or the blender jug base is not attached firmly onto the
blender jug, liquid may leak out.
Note
Disassembly and assembly of the lid unit
Assembly of the ice pack and drip tray
Use the ice pack tape strips to secure the ice pack over and
under the blender jug handle with the label facing the outer side of the pack.
Set the drip tray onto the motor housing and push it down completely.
When removing the drip tray after blending, beware of water spillage.
Note
1
Pull up the tab to open the lid.
2
Turn the cap anticlockwise and pull up to
remove it.
●
When you force open the lid unit, be careful not
to let any liquid splash. Additionally, take
caution with the emerging steam, especially
when blending hot liquids.
Note
1
2
Attach the lid gasket properly onto the lid
groove, align the lid with the ▼ mark on the
cap. Then turn the cap clockwise until the ▼
mark on the lid aligns well with the
portion
on the cap and you hear a click sound. (If the
lid gasket is not properly installed, liquid may
leak through the lid.)
Place the lid unit on the blender jug and press
down.
●
When the tamper is not in use, make sure to attach
the cap while blending.
●
When using the “Frozen” menu selection, insert the tamper
from the lid opening instead of attaching the cap.
Correct
Incorrect
●
Make sure the lid unit is attached firmly.
Note