Panasonic TH-50PB2W Operating Instructions Manual - page 12
12
Connections
Example of Network Connection (Wired LAN)
Connecting Wireless Module (Wireless LAN)
Notes:
• Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.
• To connect a device using 100BASE-TX, use “category 5” LAN cable.
• Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge.
Do not touch the LAN terminal or a metal part of the LAN cable.
• For instructions on how to connect, consult your network administrator.
Display (main unit, rear)
Hub or broadband router
LAN cable
(not supplied)
COMPUTER
Less than
10 cm
Less than
10 cm
Ferrite core
(supplied)
Ferrite core
(supplied)
Installing the Ferrite core
Pull back the tabs
(in two places)
Wind the cable
twice
Open
Press the cable
through and close
To use the wireless function, the wireless module (ET-WM200E) (sold separately) is necessary.
When connecting the wireless module to the
display, remove the protective fi lm and cap.
Connecting procedure
Hold the wireless module with its LED on the near
side and connect it to the wireless module connection
terminal.
Note:
Do not connect any other device than the wireless module
(ET-WM200E).
ET-WM200
LED
When using the electronic pen
Using the electronic pen with the wireless module
(ET-WM200E) connected may result in malfunction of
the electronic pen due to radio wave interference as
an example. In that case, set “Wireless Lan” to “Off”
before using the electronic pen. (refer to “Operating
Instructions, Network Operations”)