PLC Electronic Solutions Cini Remote 900MHz Operation Manual - 2. Installation
Cini Remote 900MHz Operation Manual
12/6/2011
PLC Electronic Solutions Ltd.
Copyright © 2011
www.plcelectronicsolutions.com
4 of 9
2. Installation
2.1. Necessary Hardware
Cini Remote Transmitter 900MHz (PLC955-0002)
o
Comes with 900MHz ¼ Wave Antenna (PLC477-0001)
o
Comes with Cini Battery Holder (PLC955-0017)
Cini Remote Receiver 900MHz (PLC955-0003)
o
Comes with 900MHz ¼ Wave Antenna (PLC477-0001)
Cini Data Cable (PLC940-0001)
2.2. Cini Remote Transmitter
Plug one end of the Cini Data Cable into the 6pin Lemo
connector of a Cine Tape
Measure System and the other end of the Cini Data Cable into the Cini Remote
Transmitter.
Attach the 900MHz ¼ Wave Antenna to the Cini Remote Transmitter.
Power up the Cine Tape Measure System, a number should now show up on the
display of the Cini Remote Transmitter. Set the desired channel using the
instructions in 3.1.1 Functionality section.