Pline JOBUS CHARNOCK Owner's Manual - page 5
www.pline.in
V1.0
Next switch the transmitter ‘ON’. The model can now be powered ‘ON’ by flipping the main power 3-
way switch in the cab downwards. Always SWITCH ‘ON’ the Tx first before POWERING ON the model.
By moving the left hand joystick gradually upwards on the transmitter the locomotive will move forward
(marked as “F” on the Tx), while gaining speed, and moving the same joystick downwards would reverse
the model (marked as “R” on the Tx), and increase speed. The model ideally should come to a stop when
the same joystick is in the neutral or centre position. This position can be adjusted using the throttle
trim slider located alongside the left hand joystick on the transmitter.
CAUTION: DO NOT RUN THE MOTORS ON FULL THROTTLE IN THE FIRST 100 MINUTES OF RUNNING. Run
the model at half throttle in any one direction for a few minutes, then stop, and then run it again at half
throttle for a few minutes more. Repeat this procedure for about half an hour until the model runs
smoothly in both directions. Once you have run your Model on half throttle in both directions on a test
track for at least about an hour, your model should be ready to run at Full throttle on the Outdoor
layout.
Sound & Horn:
When the model is powered on and not moving, you should hear the engine idling sound. As you speed
up or down in either forward or reverse directions the engine sound will also rev up or down in a
synchronized fashion, and idle when the model comes to a standstill.
The right hand side joystick on the transmitter when moved downwards blows the model’s horn
(marked as “H” on the Tx).
Lights:
The lights on the model can be operated by flipping the smaller toggle switch in the ‘ON’ or in the
downward position. The lights are directional and on the traction motors. So when the model moves in
any direction, the head, and marker lamps in that direction lights up.
Maintenance:
Clean the body of the Model with a clean soft lint free cotton cloth. To remove stubborn grease stains
from the painted surface use a detergent solution with a lint free cloth.
Always make sure that the screws on your model’s main bevel gear sets are not loose, before and after
every run. If loose tighten them gently using a M3 allen wrench and a 5mm wide flat blade screw driver.
With a little care your PLine Gauge 3 Diesel Shunter Locomotive will give you years of trouble free
running.