Plinius TAUTORO PREAMPLIFIER Instruction Manual - page 12
11
brightness then off. The next press of the button will cycle the display back to full brightness.
HT BYPASS
The HT Bypass button activates the Tautoro Home theater bypass mode. After pressing this
the Tautoro is bypassed and the signal is direct from the HT Bypass input to the outputs.
NOTE:
Because the Tautoro is bypassed in Processor mode the only buttons that
continue to function are standby and display. For more information refer to “Using the
HT Bypass Input” in the “Installation and Operation” section.
PHASE
The phase of the input signal to the preamplifier is toggled from absolute to inverted
180 degrees with each press of this button.
SOURCE SELECTION
The source selection buttons enable changing from one input to another when
needed and can be scrolled left or right to select the desired source. On reaching
the left most or right most input, the selection will scroll in a continuos loop with the
next button press.
VOLUME CONTROL
Use these two buttons to control the volume level of the preamplifier. The right side
button increases volume, while the left side button decreases the volume. Briefly
press either button to make fine adjustments to the volume level. Hold down either
button to continually adjust the volume level.
MUTE
Pressing this button toggles the PLINIUS Tautoro in and out of mute.
CD101 COMPACT DISC PLAYER CONTROLS
REPEAT
Press this button and the repeat light on the front panel will light. The CD101 will now play all
tracks on the Compact Disc as normal, but then repeat all tracks from track 1 in an endless
loop. It does not repeat one track only, it repeats the entire contents of the Compact Disc.