Plinius TAUTORO PREAMPLIFIER Instruction Manual - page 14
13
INSTALLATION & OPERATION
WARNING: RISK OF ELECTRIC SHOCK
This preamplifier operates at hazardous voltage levels. We recommend that any work
requiring removal of the lid be referred to a suitably qualified and experienced service
technician.
DO NOT
place this amplifier in any position where liquids or any foreign
material may accidentally enter it.
CAUTION!
PLEASE READ AND UNDERSTAND THE PRECAUTIONS IN THE INSTRUCTION MANUAL
FOR THE POSITION AND OPERATION OF YOUR PLINIUS PREAMPLIFIER.
CONNECTIONS
Connections to your PLINIUS Tautoro should be made in the same order as they are
listed in this section.
DO NOT
attempt to connect your PLINIUS Tautoro until you have
read and fully understood these instructions.
Although these instructions refer to the connection of the Tautoro to line level source
components, the Tautoro can also be safely installed into multimedia systems by
following the same installation guidelines. Should you require further assistance,
please contact your Plinius dealer.
SOURCE COMPONENT INPUTS
Connect your Source to the input of the PLINIUS Tautoro using suitable single-ended
RCA or Balanced XLR interconnect cables only. For RCA, make sure you connect the
red coded cable to the red RIGHT RCA input, and the white (or black) cable to the white
LEFT RCA input. Also make sure the RCA connectors are a snug fit and are inserted all
the way in. For XLR input connection, make sure you connect the RIGHT XLR input and
LEFT XLR inputs to the right and left outputs from your source respectively. Also make
sure the XLR connectors click into place.
Use the input select switch to select RCA if you are using single ended RCA cables or
to select XLR if you are using Balanced XLR cables.
NOTE:
DO NOT connect XLR and RCA at the same time, use only one or the other. For units
with optional phono installed, connect the phono/Line 1 input to a suitable audio turntable only.