Plus M-5-T Assembly Manual - Copyboard
6
MEMORY
POWER
CLEAR
POSITION
FEED
/STOP
Copyboard
M-5
Copyboard
M-5
Copyboard
M-5
Vertical Position
Image display
for vertical position
Image display
for horizontal position
(6) Vertical Image Setting.
The Copyboard is set for horizontal position when shipped from the factory. Please
set for vertical position using the following procedure.
Preparation: 1. Connect the AC power adapter to the Copyboard and the power
outlet. See the User's Manual for information about the con-
nection method.
2. Prepare a tool to press the button in the pin hole, for example a
paper clip that has been bent out, etc.
햲 Press the POWER button and switch on the power. (The Power indicator
will light.)
햳 Insert the pin into the POSITION pin hole and push.
The MEMORY indicator will blink at a slow rate for 5 seconds and the
Copyboard will be set for the vertical position.
Notice:
To switch back to horizontal, press the POSITION button again.
The POWER indicator blinks slowly for 5 seconds, and the position setting is
switched back to horizontal.
The setting switches between vertical and horizontal each time the button in the
pin hole is pressed.
Unlocked
Locked
Locking and Unlocking the Casters of the
Stand
Pressing the bottom of the lock button
will lock the casters. Pressing the top
will unlock the casters.
Note
After setup, lock the casters using the
stoppers. Unlock the stoppers before
moving the Copyboard.