Plusmed pM-KN03T Instruction Manual - Maintenance
24
ALARMS AND LIGHT INDICATIONS
1.When power ON machine, there is audible beep alarm and the green light will be on.
2.On LCD screen there is display of actual battery volume.
3.Pulse mode light will be ON or OFF with sensing if you are breathing or not.
4.No Breath Alarm
This alarm occurs when a breath is not detected for a period of 2 minutes (120 seconds) or more.
And the LCD screen will display alarm code “E01”, and the oxygen concentration display will change
to “__” This alarm can be silenced by pressing the Alarm silence button. If no breath is detected after
approximately 30 minutes, the unit shuts down to conserve power.
5. Battery power display on LCD screen
4 LEDs light: 75% to 100% full
3 LEDs light: 50% to 75%
2 LEDs light: 25% to 50%
1 LED lights: 10% to 25%
0 LED lights: 0 to 10%
When battery is less than10%, the low battery beep alarm will be on, you need to charge the battery.
6. High breathe rate alarm
User’s breath rate is exceeding the maximum capacity of the device (20BPM), the LCD screen will
display alarm code “E02”, and beep audible alarm will give.
7. Technical Fault Alarm
If any technical fault happens, the LCD screen will display alarm code “H06”
8.Power failure alarm
When machine is supplied with AC power, after the AC power is off, the machine will change to
battery power supply automatically and give one beep alarm.
9.Oxygen Concentration Alarm
When the oxygen concentration from the machine is less than 82%, the LCD screen will display
alarm code “H04” and give beep alarm.(the deviation of oxygen concentration is about 3%)
10.High temperature alarm
When the technical fault causes the machine’s inner temperature increase, the LCD screen will
display alarm code “H05” and give beep alarm.
11.Maintenance indication
The yellow light will be on to remind user that the machine needs maintenance.
MAINTENANCE
Routine Maintenance
1.In the condition of power off, make a clean for the outside case by soft wet towel with little detergent,
and then wipe it up with dry towel, once or twice per month.